I
MPORTANT
•
Never install telephone wiring during a lightning storm.
•
Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
•
Never touch non-insulated telephone wires or terminals,
unless the telephone line has been disconnected at the
network interface.
•
Use caution when installing or modifying telephone lines.
•
Temporarily disconnect any equipment connected to the
phone such as faxes, other phones, or modems.
I
MPORTANT
•
Install telephone near both a telephone (modular) jack and an
electrical power outlet.
•
Avoid sources of noise, such as a window by a busy street,
and electrical noise, such as motors, microwave ovens, and
fluorescent lighting.
•
Avoid heat sources, such as heating air ducts, heating
appliances, radiators, and direct sunlight.
•
Avoid areas of excessive moisture or extremely low temperature.
•
Avoid dusty locations.
•
Avoid other cordless telephones or personal computers.
I
NSTALLING THE
Choose the best location to install handset charge cradle. Your
handset charge cradle should be placed on a level surface such
as a desk or table top.
C
ONNECTING THE
1. Plug the power supply cord into the power jack on the back
of the charge cradle and the other into an electrical outlet.
CAUTION: Use only the ATLINKS USA, Inc.
5-xxxx (white)
other power supplies may damage the unit.
I
NSTALLATION
I
NSTALLATION
P
HONE
AC (E
power supply that came with this unit. Using
I
NFORMATION
G
UIDELINES
LECTRICAL
) P
OWER
5-xxxx (black)
and