Installing The Phone - GE 21015 User Manual

I
NSTALLING THE
1. Choose an area near an electrical outlet and telephone wall jack (RJ11C).
Your phone should be placed on a level surface, such as a table top or desk.
2. Plug the AC power supply into an electrical outlet and the DC connector
into the back of the base.
CAUTION: Use only the ATLINKS USA, Inc. power supply, 5-2621
(white) or 5-2596 (black), that came with this unit. Using other power
supplies may damage the unit.
3. Plug the handset charge cradle's AC power supply into an electrical
outlet.
4. Install a handset battery in each handset. Connect the battery pack plug
to the jack inside the battery compartment, and slide the compartment
door over the battery until it snaps into place.
NOTE: It is important to maintain the polarity (black and red wires) to the
jack inside the compartment as shown in the illustration.
10
P
HONE
PRESS DOWN
FIRMLY
BATTERY
BLACK WIRE
RED WIRE
charge