Using Relay Play; Playback Sequence; Rewind Auto Play; Demo Mode - RCA SCT-560 Owner's Manual

High-speed dubbing stereo cassette deck
Table of Contents

Advertisement

USING RELAY PLAY

You can load two cassette tapes to play one after the other.
Notes:
• The cassettes you load should have the same
Dolby NR type.
• You can start relay play from either Deck 1 or Deck 2.
• You can replace the tape in the idle deck during
relay play.
• When a tape automatically begins playing during
relay play, it always starts from the forward (3)
playback side. Be sure to set the tapes properly
before starting relay play.
• If the deck encounters an unrecorded portion of
tape more than 15 seconds long, it fast forwards
the tape until it finds another recorded portion,
and resumes playback from that point (i.e., blank
skip is automatically set).
1. Load a cassette tape in each tape
compartment, then close the compartment
doors.
2. Set
for the noise-reduction system
DOLBY NR
you want to use. See "Dolby Noise Reduction"
on Page 7.
3. Set
to
REV MODE
4. Press or on Deck 1 or 2. Playback starts. See

"Playback Sequence."

5. Adjust the volume, tone, and balance control
on your receiver/amplifier for the desired
sound.
6. To stop relay play before it automatically stops,
press
(7) on the deck that is playing
STOP
any time during playback.
Playback Sequence
The cassette deck repeats the following sequence 8 times
(up to 32 sides).
Where playback starts in the sequence depends on which
play button you press first:
I. Side facing out, Deck 1
II. Side facing in, Deck 1
III. Side facing out, Deck 2
IV. Side facing in, Deck 2
• When you press 3 on Deck 1, playback starts at I.
• When you press 2 on Deck 1, playback starts at II.
• When you press 3 on Deck 2, playback starts at III.
• When you press 2 on Deck 2, playback starts at IV.
.
RELAY/SKIP

REWIND AUTO PLAY

To have Deck 1 rewind the cassette to the beginning of the
current side and start play, press
Note: If both decks have tapes loaded, the decks operate
as described under "Using Relay Play."

DEMO MODE

The cassette deck has a demonstration mode that
alternately turns on various indicators and meters so you
can see where they show on the deck.
To turn on the demonstration mode, press
and
on Deck 2 at the same time while the cassette
RESET
deck is stopped. To cancel the mode, press any button
except
(0) and
EJECT
POWER
SPECIAL FEATURES
.
REWIND AUTO PLAY
TIME/COUNTER
.
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents