Accepting The End User License Agreement (Eula); Run The Configuration Wizard; Configuring The Network - Dell DD6300 Hardware Overview And Installation Manual

Accepting the End User License Agreement (EULA)

Run the configuration wizard

Configuring the network

Note
If you type an incorrect password four consecutive times, the system locks out the
specified username for 120 seconds. The login count and lockout period are
configurable and might be different on your system. See the Data Domain Operating
System Administration Guide and the Data Domain Operating System Command
Reference Guide for setting these values.
For Data Domain HA systems, SSH keys created on the active node take 30 seconds
to one minute to propagate to the standby node.
The first time you log in to a Data Domain system, the End User License Agreement
(EULA) is displayed.
At the end of the EULA, you are prompted to accept it:
Press any key then hit enter to acknowledge the receipt of EULA
information
Note
The customer must accept the EULA. A Data Domain representative should not accept
this agreement. If a customer is not present, press
acceptance screen and continue the installation.
The customer can later type the following to redisplay the EULA and accept it:
system show eula
The CLI configuration wizard starts automatically the first time the system starts. The
wizard prompts you through a series of questions that provide just enough information
for initial system configuration and basic network connectivity.
Note
You can begin the CLI configuration wizard manually by typing
Procedure
1. Enter to configure the system for network connectivity.
yes
Network Configuration
Configure Network at this time (yes|no) [no]:
yes
2. Enter to configure DHCP (Dynamic Host Configuration Protocol) to obtain
yes
network parameters (such as, the host name, domain name, and IP addresses)
dynamically from a DHCP server. Or enter
manually.
Use DHCP
Use DHCP for hostname, domainname, default gateway
and DNS servers? (At least one interface needs to
be configured using DHCP)
Ctrl-C
to configure the parameters
no
(yes|no|?)
Accepting the End User License Agreement (EULA)
Configure System for Use
to exit from the EULA
.
config setup
75