Table of Contents
Advertisement
Panel mount
Installing the panel mount unit requires making a cutout in the panel. The dimensions for
the cutout are provided in the illustration below. A full size cutout template is provided
with your unit or may be downloaded from www.siemens.com/processinstrumentation.
Cutout dimensions
Cutout instructions
1.
Select a place for the unit and fasten the template onto the panel (use tape or
tacks).
2.
Drill the four fastener holes.
3.
Make the cutout using the appropriate tools.
4.
Mount unit according to the instructions on page 15.
Page 14
HydroRanger 200 HMI – OPERATING INSTRUCTIONS
A5E36281317
Advertisement
Table of Contents
Troubleshooting
