Page 2
Preface Preface Thank you for purchasing this product. Before using this product, read this document carefully so that you can use this product correctly and safely. - i -...
Page 3
For safe usage For safe usage This document uses symbols for warnings, cautions, and prohibitions. These symbols and their meanings are as follows. Please make sure you fully understand the meanings of these symbols before reading the rest of this document. Indicates an item for which incorrect handling can result in a major WARNING accident involving death or serious injury.
Page 4
For safe usage CAUTION When working anywhere hardly visible, for example under the vehicle, always make the vehicle starter switch (ignition switch) OFF to ensure that the vehicle cannot be moved. Failure to do so could result in an accident. When working near the engine compartment, be careful of the engine and other high-temperature parts.
Page 5
For safe usage CAUTION Do not apply the load causing stress to the connector connected to this product. Applying too much force could result in breaking the connector terminal and this may cause malfunctioning of the vehicle, the PC and/or this product. Do not insert anything other than an SD memory card in the SD memory card slot on this product.
Page 6
For safe usage WARNING and CAUTION for Bluetooth (models with Bluetooth) WARNING Do not use this product near medical devices or inside medical facilities as it may affect electronic devices with medical applications. Make sure to keep this product at least 22 cm away from persons wearing a pacemaker. Radio wave could affect the performance of pacemaker.
Page 7
For safe usage The countries where you can use the models with Bluetooth Japan, USA, Canada, Australia, New Zealand, EU (Europian Union), Malaysia, Indonesia * In the countries other than those above, you cannot use the models with Bluetooth. Trademarks ®...
Table of contents Table of contents Before Use 1-1 Product Configuration .......................... 1 Components ............................1 1-2 Names of the Parts ..........................2 models with LCD ............................. 2 1-3 Setup..............................3 Required operating environment of the PC ..................... 3 Necessary Setup ............................. 4 1-4 Connection............................
1 Before Use Before Use 1-1 Product Configuration Check that you have all of the following standard components before using this product. Components Set Part Number: 95171-0110* (with LCD, with Bluetooth) Part Name Illustration Part No. Q'ty Main unit – T01856Z with LCD Datalink Cable...
1 Before Use 1-2 Names of the Parts The names of the product parts are as follows: models with LCD Overall B key Up/Down/Right/Left keys A key Indicators * For detailed information about indicators, refer to "Chapter 3 Indicator/3-1 Indicator". Upper side USB connector* DC jack*...
NOTE If this product is used as the interface, the operating environment of the software on a PC side is needed in addition to the above operating environment. Confirm the latest information in the following website. http://www.ds3.denso.co.jp/dst-i/dst-i.html - 3 -...
To install the DST-i setup software to a PC, log on with administrator privileges and close all running applications before installation. In installing the DST-i main unit software, execute the install by using the USB cable in the state that this product and the PC are connected.
1 Before Use 1-4 Connection Connecting to the vehicle Use the datalink cable to connect this product with the vehicle. Check the position of the diagnosis connector of the vehicle side in the repair manual of the vehicle. CAUTION Perform the connection of step 1 and step 2 according to the order. First, connect this product and the datalink cable.
PC application software finished. CAUTION You must install the DST-i setup software on your PC before you connect the USB cable to your PC. Reference: Page 4 Installing DST-i setup software to a PC (all models) (Chapter 1 Before Use/Setup/Necessary Setup) When the PC does not supply adequate power, please contact your distributor.
1 Before Use 1-5 SD Memory Card Inserting/removing an SD memory card This product can use an SD memory card inserting it into the SD memory card slot. The SD memory card may be used to install software or store vehicle data. CAUTION Depending on software, some functions with SD memory cards are not available.
2 Basic Operations Basic Operations 2-1 Starting CAUTION Perform the connection of step 1 and step 2 according to the order. Connect the datalink cable to this product. Reference: Page 5 Connecting to the vehicle (Chapter 1 Before Use/Connection) Connect the datalink cable to the vehicle side diagnosis connector. Reference: Page 5 Connecting to the vehicle (Chapter 1 Before Use/Connection) Connect this product and a PC with the USB cable.
2 Basic Operations 2-2 Ending Finish communications with the vehicle by PC application software or LCD software. CAUTION Do not turn the mode switch of this product OFF or disconnect the datalink cable from this product during the active test. The diagnosed actuators could be stopped still in the drive status.
3 Indicator Indicator 3-1 Indicator The indicators of this product provide the following information by their illumination. [Power] indicator [Error] indicator [Vehicle] indicator [PC (USB)] indicator [PC (Bluetooth)] indicator T01900E [Power] indicator Shows the status of power. Lights in green during power ON. [Vehicle] indicator Shows the status of communications with the vehicle.
5 Warranty Warranty 5-1 Warranty 1. The warranty period of this set is two years after the purchase day. However accessories are not covered, main body only. 2. Free repair warranty is applied only for the failure under proper operation conditions within the warranty period. 3.
Page 21
Hogeweyselaan 165, 1382 JL Weesp, The Netherlands Tel: +31-294-493493 Fax: +31-294-417122 Sales & Service DENSO SALES MIDDLE EAST & NORTH AFRICA FZE Address: P.O.Box 261986, Jebel Ali Free Zone South, Dubai, Tel: +971 4 880 7789 United Arab Emirates Fax: +971 4 880 7790 Sales &...
Page 22
Regulatory Information to user MODEL : DN-VIM-002 2. EMC and Radio Regulation in U.S.A. Model with Bluetooth, Model without Bluetooth FCC WARNING Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Page 23
: EN 61000-6-2 Manufacturer Name : DENSO CORPORATION Address : 1-1 Showa-cho, Kariya-shi, Aichi-ken, 448-8661 Japan Authorised representatives Name : DENSO EUROPE B.V. Address : Hogeweyselaan 165, 1382 JL Weesp, the Netherlands Sales & Service +31-294-493-493 +31-294-417-122 Model Name : DN-VIM-002...
Page 24
Co-location: This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. 3. EMC in KOREA Model without Bluetooth : DENSO CORPORATION : Diagnostic Tester (DN-VIM-003) : DENSO CORPORATION/ : KCC-REM-DKR-DN-VIM-003 : Refer to serial number on product. For more information please contact DENSO INTERNATIONAL KOREA CORPORATION. T02978Z...
Page 25
: EN 300 328 V2.1.1 Manufacturer Name : DENSO CORPORATION Address : 1-1 Showa-cho, Kariya-shi, Aichi-ken, 448-8661 Japan Authorised representatives Name : DENSO EUROPE B.V. Address : Hogeweyselaan 165, 1382 JL Weesp, the Netherlands Sales & Service +31-294-493-493 +31-294-417-122 Model Name : DN-VIM-003...
Page 27
6. Radio Regulation in MALAYSIA Model with Bluetooth Model name : DN-VIM-003 Manufacturer : DENSO CORPORATION 7. Radio Regulation in INDONESIA Model with Bluetooth 33991/SDPPI/2014 3886 8. Environmental Regulation in CHINA Table of toxic or hazardous substances contained in this product for "Management Methods for Controlloing Pollution by Electronic Information Products (China RoHS)".
Page 28
Instruction Manual 1st Ed. October, 2010 14th Ed. October, 2017 First setup date Store purchased...