Four Thread Overedging Stitch Using 2 Needles; Before Sewing; Presser Foot Lever; Beginning And Ending Of Sewing - Toyota SL1A Manual

4. FOUR THREAD OVEREDGING STITCH USING 2 NEEDLES

1. Before Sewing

After threading is completed, and when the
threads are not wound around the stitch finger,
gently draw out the four threads under and
behind the presser foot, and turn the hand wheel
towards you by hand two or three times to make
the thread wind on to the needle plate.

2. Presser Foot Lever

For setting average material, there is no need to
lower the presser foot lever.
When beginning to sew, push the material just in
front of the presser foot and it will be fed through.
For the thick material, lower the presser foot lever,
place the material under the presser foot, then
raise the presser foot lever.

3. Beginning and Ending of Sewing

Beginning to sew
Just put your left hand on the material to push
it slightly until the tip of the fabric comes exactly
behind the presser foot.
FOUR THREAD OVEREDGING STITCH USING 2 NEEDLES
1 -15