Download Print this page

Dimplex EMC4240 Installation Instructions page 2

Construction heaters
Hide thumbs Also See for EMC4240:

Advertisement

Operation
WARNING: This heater must be properly installed before it
is used.
SETTING THE THERMOSTAT
1. Before connecting or disconnecting plug, turn knob fully
counterclockwise.
2. Heater is equipped with a thermostat.
perature to your individual requirements, turn thermostat
control knob clockwise all the way to turn heater on. The
yellow power light will illuminate (Figure 4). When room
reaches desired temperature, turn thermostat knob coun-
terclockwise until you hear a click. Leave in this position to
maintain room temperature at this setting. For additional
heat, turn clockwise until you hear a click again and heater
will turn on. To shut heater off turn thermostat knob coun-
terclockwise all the way. The yellow power indicator light
will turn off.
WARNING: Should the heater overheat, an automatic cut
out will turn the heater off and it will not come back on with-
out being reset. It can be reset by unplugging the unit and
waiting 5 minutes before plugging the unit back in.
If you need to continuously reset the heater, unplug the
unit and contact a licenced electrician. DO NOT USE THE
HEATER UNTIL THE CAUSE OF THE BROBLEM IS DE-
TERMINED AND FIXED.
Figure 4
Red light
Over Temp
Surchauffe
Temperatura
Excesiva
Power On
En marche
Encedido
Yellow light
1367 Industrial Road Cambridge ON Canada N3H 4W3
1-888-346-7539 www.dimplex.com
In keeping with our policy of continuous product improvement, we reserve the right to make changes without notice.
© 2016 Dimplex North America Limited
Maintenance
WARNING: Disconnect power before attempting any main-
tenance or cleaning to reduce the risk of fire, electric shock or
damage to persons.
CAUTION: Allow at least 30 minutes for the heater to cool
before attempting any maintenance or cleaning.
!
NOTE: This heater should not be operated with an ac-
To adjust tem-
cumulation of dust or dirt on or in the unit, as this can cause
a build up of heat and eventual damage. For this reason the
heater must be inspected regularly, depending upon condi-
tions and at least at yearly intervals.
To clean the exterior surface, use a solution of water and mild
detergent, apply with damp sponge. Wipe dry with a dry cloth.
DO NOT plug heater into outlet until it has dried thoroughly.
Dimplex Electric Heaters are tested and inspected prior to shipment and are
guaranteed free from defect to the purchaser of each new product. Any part
which proves to be defective in material or workmanship under normal use
within one year will be repaired or replaced without charge. The Company
will not be responsible for any expense incurred for installation, removal from
service, or transportation costs. Any such defect should be brought to the
attention of the Dealer where the product was purchased and is authorized to
repair or replace within the terms of this warranty.
The Company's only obligation under this warranty will be at its sole option
to repair or replace any part proving defective or to refund the purchase price
thereof.
The owner/user assumes all other risks, if any, including the risk of any direct,
indirect or consequential loss or damage arising out of the use of or inability
to use the product.
The warranty will not apply if, in the sole judgment of the Company, damage
O
or failure has resulted from accident, alteration, misuse, abuse, incorrect
Low
installation, or operation on an incorrect power source.
The foregoing is in lieu of all other warranties expressed, implied, or statutory,
High
and the Company neither assumes, nor authorizes any person to assume for
it any other obligation, or liability in connection with said product.
Warranty

Advertisement

loading

This manual is also suitable for:

Dch4831