Device maintenance and repair
7.3 Installing and removing hardware
7.3.2
Changing storage media
7.3.2.1
Replacing a HDD/SSD
This procedure applies to the replacement of the built-in HDD or SSD.
Requirement
● The device is disconnected from the power supply.
● The device is removed.
● 1 T10 screwdriver
Procedure
Note
Observe the guidelines for handling electrostatic-sensitive components in section "ESD
guideline (Page 98)".
Removal
1. Remove the wall mounting bracket or the
vertical mounting bracket, if any, and
then the indicated screws.
Push the cover in the direction indicated
and lift it off.
2. Remove the marked screws.
These screws secure the HDD/SSD.
78
Operating Instructions, 09/2017, A5E37454814-AB
SIMATIC IPC427E