Husqvarna Viking Opal 690Q User Manual page 40

PROGRAMMING (670/690Q)
The Programming function on your machine makes it possible to create stitches with your own personal settings and to
sewing and bartacks.
1. Touch the PROG icon to open the mode for
Programming.
2. The stitch menu which was previously selected will be kept
when entering the Programming mode. To change the
stitch menu, see page 37.
last entered stitch.
Note: Two numbers are displayed on the TouchScreen below the stitch
of the selected stitch in the program. The second number, put in brackets,
is the total number of stitches in the program.
The number above the stitch program (C) on the right side of the
TouchScreen is the number of the selected stitch.
Add Letters
alphabet in Programming Mode.
6. Touch to select a letter and to add the letter to the
program.
7. To switch to a lower case alphabet or numbers touch the
Both upper and lower case letters will be stitched with a
7 mm stitch width. If there are letters going below the
uppercase letters will be reduced.
All text to be sewn out on the same project should, if possible,
be in the same program to ensure the letters are sewn out in
the same height.
Add Stitches or Letters at other Positions
If you wish to add a stitch or letter at another position in the
The stitch or letter will be inserted to the right of the cursor.
™
A
B
Programming Mode
A. Stitch program
B. Position of selected stitch in the program/
total number of stitches in program
C. Selected stitch and stitch menu.
D. Selection arrows used to step through the
program
E. Delete the selected stitch
F. Touch Alt to toggle between different settings.
C
D
E
F
G