Depth Units; Speed Units; Temp Units; Speed - Raymarine L365 Instruction Manual

silence the buzzer for the current alarm condition . The
"S" or "D" symbol will continue to flash as long as the alarm
condition is still present.
If the alarm condition occurs again, the buzzer will sound
again. (For example, this would happen if, after a shallow
alarm you move into deep water, then return to shallow
water.) You can silence the buzzer again by pressing the
button.
CLEAR
The Buzzer entry in the System Setup display allows you to
permanently silence the buzzer for all of the alarms. Use
<
the and
symbol at the bottom of the screen will appear hollow.
Once you do this, if a shallow alarm or deep alarm occurs,
the "S" or "D" symbol will flash, but the buzzer will not
sound. You can enable the buzzer again at any time by
calling up the System Setup display, going to the line for
Buzzer, and turning the item on again. The buzzer symbol
at the bottom of the screen will appear solid.
Each time you press one of the buttons on the display
panel, the buzzer will "beep." The buzzer will continue to
do this, regardless of the setting of the Buzzer option in the
System Setup display.

Depth Units

This item sets the units used by the depth display. You can
choose feet (FT), fathoms (FA), or meters (M). Use the
>
and controls to make your choice.
Speed Units This item sets the units used by the speed display. The
same units are used for the distance ("log") display. There
are three choices:
Code
MPH
KTS
KPH
Setup Instructions
>
controls to turn this item on or off. The buzzer
Units used for speed
Miles per hour
Knots
Kilometers per hour
<
Units used by log
Statute miles
Nautical miles
Kilometers
59