Dealer Calibration - Raymarine ST40 Wind Owner's Handbook Manual

Chapter 4: Calibration
4.3 Intermediate calibration
Intermediate calibration enables you to:
• Check the instrument software version.
• Check the instrument status - either master (shown as RPTR NO) or
Follow the procedure in the Intermediate calibration flow diagram.

4.4 Dealer calibration

Dealer calibration enables you to set:
• User calibration on/off.
• Boat show mode on/off.
Dealer calibration also gives access to the Factory defaults screen.
This enables you to reapply the factory settings if you want to reset the
instrument to a known operating condition.
Follow the procedure in the Dealer calibration flow diagram.
repeater (shown as RPTR YES). You cannot change this.
INTERMEDIATE CALIBRATION
hold down
Software
version
ST40
Instrument
status
CAL
ST40
To return to normal operation from either screen,
hold down
During normal operation
and for approximately 4 seconds
Note:
If there is no key activity when
the Software version screen
is displayed, calibration will
time out to normal operation
after 5 seconds
WIND
WIND
and for approximately 2 seconds
25
D4765-2