Connections To The Instrument - Raymarine ST40 Wind Owner's Handbook Manual

16

Connections to the instrument

You can connect your instrument:
• Directly to the Rotavecta, transducer as a stand-alone master
• As part of a SeaTalk system either as a repeater or, with a wind
You can also connect the instrument to both the Rotavecta transducer
and SeaTalk. When thus connected, the instrument will be the master
wind instrument for the SeaTalk system.
If it is necessary to fit spade connectors to the transducer cable, do so as
shown in the following illustration. Prepare the cable, as at (a), and fit
the spade connectors, as at (b). When fitting each spade connector,
ensure that wire strands do not extend beyond the rear of the spade
connector insulation.
Preparing wires for connection
instrument. When connected in this manner, the instrument must be
connected to a suitable power source using the 1 m (3 ft) power
cable provided.
transducer also connected as a system master. To connect to
SeaTalk, you will need an additional SeaTalk Interconnection Kit
(Part No. E25028). When connected in this manner, power can be
provided from the SeaTalk bus (e.g. from the autopilot).
ST40 Wind Instrument Owner's Handbook
50 mm
(a)
4 mm
3 mm
(b)
10 mm
D4467-3