Outdoor Use - Lochinvar COPPER-FIN II CF401 Designer's Manual

Lochinvar
(FIG. 2) MODELS CF 401-751 INSTALLED WITH
5.
Outdoor models require the installation of
an optional vent cap. Instructions for
placement of the vent cap are included in
the venting section.
CLEARANCES
Right Side
Rear
Left Side
Front
Top
Flue
Hot Water Pipes
* Alcove is a closet without a door.
** Consult local codes and/or vent manufacturer.
4
L o c h i n v a r
OPTIONAL COMBUSTIBLE FLOOR BASE
(TABLE B) – CLEARANCES FROM COMBUSTIBLES
'
D E S I G N E R S G U I D E C O P P E R
Outdoor models must not be installed
directly on the ground. The outdoor unit
must be installed on a concrete brick,
block or other non-combustible pad.
Outdoor models have additional special
location and clearance requirements.
(See Outdoor Venting Pg. 16)
SPECIAL LOCATION:

OUTDOOR USE

Outdoor models have additional location
and clearance requirements. These
requirements must be adhered to carefully,
since wind, rain, snow and cold cannot be
controlled in outdoor applications. See
Outdoor Installation, in the venting
section on page 16.
CF 401-751
1"
1"
6"
(24" for Service)
ALCOVE*
(24" for Service)
1"
1"**
1"
-
F I N I I W A T E R H E A T E R
CF 991-2071
3"
3"
3"
(24" for Service)
ALCOVE*
(30" for Service)
3"
1"**
1"
6 1 5 - 8 8 9 - 8 9 0 0