Codes - Lochinvar COPPER-FIN II CF401 Designer's Manual

Lochinvar
o
o
o
o
o
o
2
L o c h i n v a r
In designing
a water heater system,
pay special attention to:
Water Velocity
(See page 19 for Required
Temperature Rise chart.)
Factory Supplied Pump
Capacity
(See page 19 for Pump Operation.)
Manifold Pipe Size
When using more than one heater
(See page 20 for Common Water
Manifold Size for Multiple Water
Heater Installation Table.)
Storage Tank Circulating
Tappings
(See page 20 for Manifold Pipe
Size.)
Placement of Cold Water
Inlet and Building Return
(See Pages Appendix A for Water
Heater Piping Diagrams.)
Water Hardness
(
See page 19 for Water Treatment
Information.)
'
D E S I G N E R S G U I D E C O P P E R

CODES

The equipment shall be installed in
accordance with those installation
regulations in effect in the local area where
the installation is to be made. These shall
be carefully followed in all cases. Authorities
having jurisdiction shall be consulted before
installations are made.
In the absence of such requirements, the
installation shall conform to the latest edition of
the National Fuel Gas Code, ANSI Z223.1.
Where required by the authority having
jurisdiction, the installation must conform to
American Society of Mechanical Engineers
Safety Code for Controls and Safety Devices
for Automatically Fired Boilers, ASME CSD-1.
Where required by the authority having
jurisdiction, the installation must comply with
the Canadian Association Code, CAN/CGA-
B149.1 and/or B149.2 and/or local codes.
LOCATION OF UNIT
1. Locate the unit so that if water connections
should leak, water damage will not occur.
When such locations cannot be avoided, it
is recommended that a suitable drain pan,
adequately drained, be installed under the
unit. The pan must not restrict combustion
air flow.
-
F I N I I W A T E R H E A T E R
6 1 5 - 8 8 9 - 8 9 0 0