Timing The Sewing Machine - Brother Dream Quilter 15 Service Manual

Timing the Sewing Machine

Tools Needed:
• 2mm Allen Wrench - Red Handle
• Timing Spacer
1. Remove needle plate.
2. Loosen all three hook assembly set screws with a M2 allen wrench by inserting the wrench
into the machines timing hole cut out when each set screw aligns with the hole.
3. Rotate the handwheel clockwise from the front of the machine so needle is raising out of
the hook assembly.
4. Bring the needle so it rests on the top of timing spacer, so the groove in the needle aligns
in the middle of the hook on the hook assembly. The needle should be as close as possible
to the hook assembly without touching, roughly between 0.02mm and 0.075mm.
5. Tighten set screw, make sure needle doesn't hit hook by watching to see if the needle
bends during rotation and there is no clicking noise. Rotate machine using the handwheel
a full rotation to ensure the needle doesn't hit anywhere during rotation. If needle hits
the hook assembly anywhere during rotation adjust needle height up or down off center
from hook in 0.25mm increments as appropriate to clear the collision.
6. Tighten the two remaining set screws and reattach the needle plate.
Hook
Assembly
A timing tutorial is availablie on our website
http://www.qniquequilter.com/videos/tutorials/
CODE
Needle
Set
Screws
0.02-0.075mm Gap
Scarf
Hook
at:
QR
2mm Allen
Wrench
Timing Hole
Cut Out
8
Assembly
Timing Spacer
Tip Of Needle