Thread Take-Up Lever Link Removal; Needle Bar Assembly Removal - Brother BC800 Service Manual

Main unit
5

Thread take-up lever link removal

1. Remove the retaining ring (E5) and spring washer 1, and then remove the
thread take-up lever link 3 from the shaft 2.
2. Remove the screw 1, and then pull the shaft 2 out of the base holder.
Start movie clip (CD-ROM version only)
6

Needle bar assembly removal

1. Loosen the screws 1 and 2, and then pull the needle bar 1 down and
remove the needle thread block 2 and the needle bar block 3.
Start movie clip (CD-ROM version only)
6-1
Needle bar ASSY disassembly
1. Remove the screw 1, and then remove the needle block assy 1.
Needle-presser unit
1 2
Retaining ring E5
3 1
3 2 1 2
1
1 1
2 - 29