Radio Shack 61-3010 User Manual

home automation
remote control wall switch
Thank you for purchasing the RadioShack Home
Automation Remote Control Wall Switch. Your
remote control system includes an ultra-slim,
stick-on RF wall switch and a Plug 'n Power
receiver. Using the wall switch, you can operate
three individually-coded Plug 'n Power modules
and brighten or dim lights connected to lamp
modules and wall switch modules. You also can
control lamps and appliances attached to other
Plug 'n Power devices, which are available at
your local RadioShack store.
Please read this user's guide before
installing, setting up and using your new product
www.radioshack.com
installing your receiver
61-3010
 Using a small
screwdriver, set
the House Code
dial of the receiver
to the desired letter.
 Plug the receiver
into an AC outlet, and
then fully extend the
receiver's antenna.
 Plug the desired lamp or appliance into the
receiver.
Your transmitter comes with one CR2032 lithium battery installed. When your lamp or appliance
does not respond to the transmitter's command, replace the battery.
 Pull out and remove the battery holder at the bottom of the wall
switch.
 Insert a new lithium battery with its positive (+) side facing up.
 Replace the battery holder.
Battery Cautions:
• Keep button-cell batteries away from children. Swallowing a
button-cell battery can be fatal.
• Dispose of the old battery promptly and properly. Do not
burn or bury it.
• Use only a fresh battery of the required size and
recommended type.
labeling your wall switch keys
Remove one or more tags from the supplied
card and write the appropriate information
(lamp, fan, etc) on each one. Remove the
plastic cover from each key and place a tag
under each cover. Replace the cover when
finished.
mounting your wall switch
Your wall switch comes with an adhesive
backing to easily mount on a flat surface.
 Select a mounting location.
 Make sure the wall switch operates the
receiver before permanently placing it.
 Remove the adhesive backing from
the wall switch and press it against the
mounting surface.
replacing your battery