Table of Contents
Advertisement
16-635.fm Page 48 Wednesday, July 21, 1999 9:03 AM
ADDITIONAL INFORMATION
TROUBLESHOOTING
If you follow the instructions in this manual and still have trouble operating your VCR, look in this
chart for the problem description and its solution. If your VCR still does not work properly, contact
your local RadioShack store.
PROBLEM
No power.
Timer recording did not work,
or a broadcast was recorded
at the wrong time.
VCR Plus+ recording did not
work, or a broadcast was re-
corded at the wrong time or
on the wrong channel.
Cannot record.
Picture is poor on playback.
The playback picture is dis-
torted.
No picture on playback.
Remote control buttons do
not work when the power is
on and a cassette is loaded.
48
POSSIBLE SOLUTION
The power cord is not connected. Plug the power cord into an AC
outlet.
The power is on. Turn off the power.
The timer is not set or is set incorrectly. Check the timer settings.
The power is on. Turn off the power.
VCR Plus+ is not set or is set incorrectly. Check the VCR Plus+
settings.
The guide channels are not set correctly. Check the guide channel
settings.
The erase-protection tab is missing. Place a piece of tape over the
tab hole.
The TV is not set to the proper channel. Set the TV to the same
channel as
on the back of the VCR.
3-CH-4
The TV's fine tuning is not set correctly. Fine tune your TV.
Audio/video connections are incorrect. Check all connections.
The video heads are dirty. See "Cleaning the Video Heads" on
Page 51.
The VCR might not have adjusted tracking correctly. You might
need to manually adjust tracking (see "Tracking" on Page 30).
The TV is not set to the proper channel. Set the TV to the same
channel as
on the back of the VCR., or to its audio/video in-
3-CH-4
put if you connected it to the VCR's
Audio/video connections are incorrect. Check all connections.
Something is blocking the path from the remote control to the
VCR.
jacks.
R-AUDIO-L/VIDEO OUT
Advertisement
Table of Contents
