Grandstream Networks DP760 User Manual page 22

Status
Repeater Status
Signal
Strength
Number
of
Active
Calls
•
Global Functions
•
Network Status
Shows Device ID in hexadecimal format. This is needed by network administrators
for troubleshooting. The MAC address will be used for provisioning and can be
MAC Address
found on the label on original box and on the label located on the bottom panel of
the device.
IP Address Mode Indicates used IP address mode: DHCP, Static IP or PPPoE.
IP Address Displays assigned IP address. Example: 192.168.5.110
Subnet Mask Displays assigned subnet mask. Example: 255.255.255.0
Gateway Displays assigned default gateway. Example: 192.168.5.1
PPPoE Link Up Indicates PPPoE connection status.
Describes the repeater status:
•
Scanning for available RFPs: DP760 is scanning and searching
for available RFPs (Radio Fixed Part Identity) address.
•
Repeater is searching for the requested RFP: DP760 DECT
repeater is searching for DP750 base station configured RFPI.
(During manual association)
• Repeater is in normal operation: DP760 DECT repeater is
operational and associated with the DP750.
Note: The message "Repeater is operational after auto configuration
procedure first
association.
Displays the signal strength of the DECT repeater.
Displays number of active calls on the DECT repeater.
Base Station RFPI Address: Displays the RFPI address of the associated
base station.
Disconnect: Disconnect the DP760 DECT Repeater from the DP750 Base
Station.
DP760 User Manual
Version 1.0.3.34
time" appears briefly during DP760/DP750
P a g e | 22