For More Information, Visit Www.desatech.com For More Information, Visit Www.desatech.com - Comfort Glow CGFB32CA Circulating Louvered Safety Information And Installation Manual

INSTALLATION
Continued
INSTALLING FIREPLACE HOOD
NOTICE: The firebox canopy (hood) must not be
modified or replaced with a canopy (hood) that may
be provided with the unvented decorative room heater.
1. Attach three zinc-colored shoulder screws to back of hood.
2. Insert hood into hood-mounting slots on firebox.
3. Hold hood in place. Insert two black Phillips screws through
bottom of hood and tighten.
Hood
Figure 11 - Installing Fireplace Hood
INSTALLING FIREPLACE SCREEN
1. Insert each rod through nine rings located at top of screen (see
Figure 12).
2. Insert first rod into rear hole in left side of firebox. Fasten rod
to rear hole near center of firebox using black shoulder screw.
3. Insert other rod into front hole on right side of firebox and
fasten using remaining shoulder screw.
Front and
Rear Hole
Rod
Ring
Screen
Figure 12 - Installing Fireplace Screen
For more information, visit www.desatech.com
For more information, visit www.desatech.com
107331-01E
Firebox Installation Using Optional Accessory Mantels
Hood Mounting Slot
Shoulder Screw
Screw
Screw
Installing Fireplace Hood
Installing Fireplace Screen
FIREBOX INSTALLATION USING OPTIONAL
ACCESSORY MANTELS
This firebox may be installed using the cabinet mantel and hearth
base accessories against a wall in your home. Follow the instruc-
tions below to install the firebox in this manner.
Note: The instructions below show installation using GMC11F/
GMC12U/GMC13F series cabinet mantels and the GC3333F/
GC3334U/GC3335F series hearth base accessories. The hearth
base accessory shown is optional for this installation. You can
install firebox and cabinet mantel directly on the floor.
1. Assemble cabinet mantel, hearth base, and perimeter trim (In-
cluded with mantel). Assembly instructions are included with
each accessory.
2. If using an optional GA3750 blower, install a properly
grounded, 120 volt three-prong electrical outlet at firebox lo-
cation if an outlet is not there. If possible, locate outlet so cabi-
net mantel will cover it when installed (see Figure 14).
3. Install gas piping to firebox location. This installation includes
an approved flexible gas line (if allowed by local codes) and a
equipment shutoff valve. The flexible gas line must be the last
item installed on the gas piping. See Connecting to Gas Sup-
ply in your log set owner's manual.
WARNING: A qualified service person must con-
nect firebox to gas supply. Follow all local codes.
4. Place hearth base accessory against wall at installation loca-
tion. Cut an access hole in hearth top to run flexible gas line to
firebox (see Figure 13). Make sure to locate access hole so
cabinet mantel will cover it when installed. Note: You can
secure base to floor using wood screws. Countersink screw
heads and putty over.
5. Route flexible gas line through access hole in hearth base.
Rigid Pipe
and Gas
Hearth
Shutoff Valve
Base
Figure 13 - Placing Hearth Base Accessory Against Wall
INSTALLATION
9 9
Electrical Outlet
Gas Line
Access Hole