Safety Information, General Notes & Lead Free Requirements 3139 785 34110 EN 5 Safety Information, General Notes & Lead Free Requirements Safety Instructions Warnings 2.1.1 General Safety 2.2.1 General Safety regulations require that during a repair: • All ICs and many other semiconductors are susceptible to •...
Page 6
Gemstar Development Corporation. The “Video Plus+” system is manufactured under licence from the Gemstar • Use only lead-free solder alloy Philips SAC305 with order Development Corporation. code 0622 149 00106. If lead-free solder-pate is required, please contact the manufacturer of your solder-equipment.
Directions For Use The following except of the Quick Use Guide serves as an introduction to the set. The Complete Direction for the Use can be downloaded in different languages from the internet site of Philips Customer care Center: www.p4c.philips.com...
Mechanical Instructions 3139 785 34110 EN 9 Mechanical Instructions Note : The position numbers given here refer to the Exploded view in chapter 9 Dismantling of the Front Complete Assembly Dismantling of the DVD Tray Cover manually 1) Remove 5 screws to loosen Top cover 240 . 2) Remove 2 screws on the frame 161 as shown in figure 3.
Page 10
EN 10 3139 785 34110 Mechanical Instructions Dismantling of the Basic Engine 1) Remove 4 mounting screws as shown in figure 6 to dismantle the Basic Engine 1001. Figure 4-b - Unscrew the side screw 3) Remove 2 screws to detach the Loader Shield Bracket 198.
Page 11
Mechanical Instructions 3139 785 34110 EN 11 Dismantling of the PSU Board Dismantling of the ANABE Board and Tuner Board 1) Remove 3 screws and release 2 spacers as shown in figure 8 to dismantle the PSU Board 1002.. 1) Remove 5 screws on the frame 161 as shown in figure Figure 8-Unscrew the screws and release the spacers 2) Service Position for PSU Board 1002 is shown in figure 9.
Page 12
EN 12 3139 785 34110 Mechanical Instructions 3) ANABE Board service position is shown in figure 12. Insulation Sheet Figure 12-ANABE Board Service Position (Front Panel also dismantled) Note: beware of the cable connection from PSU Board...
Press <8> <1> <0> <5> in succession. • The set will display a version information dialog box The figure below shows the version information displayed by DVDR3600/31 running backend software version (software release version) R03_06 and optical drive firmware 68.09.26.00. Software release version Optical Drive firmware...
Page 14
EN 14 3139 785 34110 Firmware Upgrading and other useful firmware hints 5.4. Restore the Dynamic Stroke Version It is important to restore the Dynamic Stroke version of the set before returning the set to the customer. Follow the steps below to restore dynamic stroke versions: •...
LED DRIVER LED DRIVER PT6961 PT6961 FRONT FRONT KEYS KEYS LED DISPLAY LED DISPLAY SETNAME DVDR3600 CLASS_NO 2007-09-01 E BUILDING BLOCK 3139 249 4446 DVDR3600 EU 2007-09-01 NAME CHAI KOH WEE SUPERS. ROYAL PHILIPS ELECTRONICS N.V. 2007 CHECK DATE 2007-07-16...
Block Diagrams, Waveforms, Wiring Diagram. 3139 785 34110 EN 19 Test Points Overview for ANABE Board Anabe Test Point 3139 243 38263_a3.pdf_2 May 2008...
IC description 3139 785 34110 EN 35 IC Internal Block Diagram 8.1. Front Board IC7101-PT6961-LED Driver IC Block Diagram SG1/KS1 SG2/KS2 SG3/KS3 Control SG4/KS4 SG5/KS5 Serial DOUT Data Display SG6/KS6 Interface Memory SG7/KS7 SG8/KS8 Segment Driver/ SG9/KS9 Key Scan Output/ Timing Generator Grid Driver SG10/KS10...
Page 36
EN 36 3139 785 34110 IC Description PIN CONFIGURATION DOUT PT6961 SG1/KS1 SG2/KS2 SG12/GR7 SG3/KS3 SG11 SG10/KS10 SG4/KS4 SG9/KS9 SG5/KS5 SG8/KS8 SG6/KS6 SG7/KS7 Figure 8-2 Pin Name Description Pin No. Oscillator Input Pin A resistor is connected to this pin to determine the oscillation frequency Data Output Pin (N-Channel, Open-Drain) DOUT...
Page 37
IC description 3139 785 34110 EN 37 8.2. ANABE Board IC7301-STMPS2141-USB IC Limiter Block Diagram V IN V OUT Current sense Driver UVLO Fault Thermal Fault blanking/reporting sense driver control unit Figure 8-3...
Page 38
EN 38 3139 785 34110 IC Description Pin Description EN_N FAULT SO8\TSSOP8 Figure 8-4 Pin N° Name Function TSSOP8 SOT23-5L Ground 2.7V - 5.5V Input 2.7V - 5.5V Input Enable for power switch FAULT Open drain FAULT indicator, Active Low Output of power switch Output of power switch Output of power switch...
Page 40
EN 40 3139 785 34110 IC Description Pin Description Pin number Symbol Type Description SCLK System clock CTL0 Control lines. The signals control the communication between the LLC. Bus holders are built in these signals. CTL1 4-11 Data lines. The data signals between the MT8162 and the LLC. Bus holders are built in these signals.
Page 41
IC description 3139 785 34110 EN 41 Pin number Symbol Type Description ATEST Analog test terminal. This signal is used in manufacturing test. VREF Analog reference voltage input. RESET_B Power-on reset. This is an active low signal. 38,39 ATESTN Analog test terminal ATESTP PLLVDD PLL circuit power...
Page 44
EN 44 3139 785 34110 IC Description Pin Description AIN2L Analogue Input Channel 2 left input multiplexor virtual ground Channel 1 right input multiplexor virtual ground AIN1R Analogue Input Channel 1 left input multiplexor virtual ground AIN1L Analogue Input DACBCLK Digital input/output DAC audio interface bit clock DACMCLK...
Page 45
IC description 3139 785 34110 EN 45 IC7711-CS4344 10-pin, 24-Bit, 192 kHz Stereo D/A Converter Block Diagram 3.3 V or 5 V Switched Multibit Interpolation Capacitor Left De-emphasis Filter ∆Σ Modulator DAC and Output Filter Switched Multibit Interpolation Capacitor Right Serial Audio ∆Σ...
Page 46
EN 46 3139 785 34110 IC Description IC7600-STV6417-Audio/Video Switch Video Block Diagram FBIN_ENC FBIN_ENC FBOUT_TV FBIN_VCR FBIN_VCR FB Switch BOUT_TV BIN_ENC B/PbIN_ENC SY/BOT 7MHz Bypass BIN_VCR 3 to 9 dB B/PbIN_VCR Mute SY/BOT G/Y/CIN_ENC G/Y/CIN_ENC 7MHz Bypass BOT/AV G/YIN_VCR 3 to GOUT_TV 9 dB G/YIN_VCR...
Page 47
IC description 3139 785 34110 EN 47 Audio Block Diagram LIN_ENC LIN+_ENC LIN_TV LOUT_VCR 0/6/9 dB DIFF/SE Mute LIN-_ENC Stereo/Mono RIN_ENC RIN_TV ROUT_VCR Mute RIN+_ENC Hz-Mode DIFF/SE 0/6/9 dB VCR Switch RIN-_ENC AOUT_RF 0/6 dB LIN_TV Hz-Mode LIN_ENC LIN_VCR LIN_VCR -62 dB 0/6 dB...
Page 48
EN 48 3139 785 34110 IC Description Pin Description VCCA 9V Audio Supply Voltage Output (must be decoupled by capacitors) DECAV Audio/VideoDecoupling Capacitor VCC12 12V Supply Voltage input GNDref Audio/Video Reference Voltage Ground LIN_TV Audio Left, Input from TV SCART RIN_TV Audio Right, Input from VCR SCART LIN_VCR...
Page 49
IC description 3139 785 34110 EN 49 Pin Description BOUT_TV Blue Output to TV SCART GOUT_TV Green Output to TV SCART R/COUT_TV Red/Chroma Output to TV SCART COUT_VCR Chroma Output to VCR SCART Y/CVBSOUT_VCR Y/CVBS Output to VCR SCART Y/CVBSOUT_TV Y/CVBS Output to TV SCART VCC1 +5V Video Input Supply...