Philips DVDR600VR/37 Service Manual page 161

EN 10 5. VAD8041
error error
code
0x39 opc_power_calculation_er
ror
0x3A opc_test_zone_full_error
0x3B opc_bad_jitter_measurem
ent_error
0x3C opc_read_samples_error
0x3D ropc_alpha_overflow_error The determined value for the op-
0x3E ropc_alpha_ref_current_er
ror
0x3F ropc_alpha_gain_error
0x40 beta_over_under_flow_err
or
0x41 not_enough_calib_points_
error
0x42 not_enough_power_error
0x43 illegal_reading_speed_err
or
0x44 servo_fatal_error
This error is overwritten by the next player / inquiry command.
Service Modes, Error Codes and Fault Finding
meaning
Error during OPC power calcula-
tion (samples are wrong)
OPC can't be performed because
test zone is full
The jitter measurement during
OPC samples readback failed
An error occurred during OPC
readback sampling
timum power is too high
The alpha measurement refer-
ence current is wrong (IAN)
The alpha measurement alpha
gain is wrong
During the walking OPC a beta
over-/under-flow was detected
Not enough valid calibration
points available for re-calibration
The calculated power during re-
calibration exceeds max power
The selected speed is not al-
lowed for the requested com-
mand
The actuator dissipation became
too high during a servo recovery