Table of Contents
Advertisement
Ensure that the voltage across the DC power source cable leads is 0 V and that
1.
there is no chance that the cable leads might become active during installation.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
2.
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see "Preventing Electrostatic Discharge Damage" on page 9.
Orient the power supply as follows:
3.
For SRX 3400, orient the power supply so that the locking lever is on the
left as shown in Figure 2 on page 5.
For SRX 3600, orient the power supply so that the locking lever is on the
right as shown in Figure 3 on page 5.
Figure 2: Installing a DC Power Supply, SRX 3400
Figure 3: Installing a DC Power Supply, SRX 3600
Installing a DC Power Supply
Installing a DC Power Supply
5
Advertisement
Table of Contents
