Emerson Rosemount 3300 Series Reference Manual page 129

Reference Manual
00809-0100-4811, Rev AB
July 2003
Message
Overwrite existing
configuration memory
Press OK...
Restore device value?
Save data from device to
configuration memory
Saving data to
configuration memory.
Sending data to device.
There are write only variables
which have not been edited.
Please edit them.
There is unsent data. Send it
before shutting off?
Too few data bytes received
Transmitter Fault
Units for <variable label> has
changed. Unit must be sent
before editing, or invalid data will
be sent.
Unsent data to online device.
SEND or LOSE data
Use up/down arrows to change
contrast. Press DONE when
done.
Value out of range
<message> occurred
reading/writing <variable label>
<variable label> has an unknown
value. Unit must be sent before
editing, or invalid data will be
sent.
Table C-2. HART Communicator Diagnostic Messages
Description
Requests permission to overwrite existing configuration either by a device-to-memory transfer or by
an offline configuration. User answers using the softkeys.
Press the OK softkey. This message usually appears after an error message from the application or
as a result of HART communications.
The edited value that was sent to a device was not properly implemented. Restoring the device value
returns the variable to its original value.
Prompts user to press SAVE softkey to initiate a device-to-memory transfer.
Data is being transferred from a device to configuration memory.
Data is being transferred from configuration memory to a device.
There are write-only variables which have not been set by the user. These variables should be set or
invalid values may be sent to the device.
Press YES to send unsent data and turn the HC off. Press NO to turn the HC off and lose the unsent
data.
Command returns fewer data bytes than expected as determined by the device description.
Device returns a command response indicating a fault with the connected device.
The engineering units for this variable have been edited. Send engineering units to the device before
editing this variable.
There is unsent data for a previously connected device which must be sent or thrown away before
connecting to another device.
Gives direction to change the contrast of the HC display.
The user-entered value is either not within the range for the given type and size of variable or not
within the min/max specified by the device.
Either a read/write command indicates too few data bytes received, transmitter fault, invalid response
code, invalid response command, invalid reply data field, or failed pre- or post-read method; or a
response code of any class other than SUCCESS is returned reading a particular variable.
A variable related to this variable has been edited. Send related variable to the device before editing
this variable.
Rosemount 3300 Series
C-11