Instructions That Cannot Be Used With Operation Outputs - Mitsubishi Electric MELSEC-Q Series Programming Manual

Instructions that cannot be used with operation outputs

The following table lists instructions that cannot be used with operation outputs.
Class
Master control
End
Program branch
Program control
Structuring
Debugging troubleshooting (The Basic
model QCPU, Universal model QCPU,
and LCPU do not support the
function.)
SFC dedicated instruction
*1 ? = N, D, SC, SE, ST, R, C, G, I, ID, ISC, ISE, IST, IR
*2 ? = L, O, OA, OC, OCA, A, C, CA, CO, COC
*3 Label P cannot be used, either.
*4 Label I cannot be used, either.
Instruction Code Symbol
MC MC N No.1_D
MCR MCR N
FEND FEND
END END
CJ CJ P
SCJ SCJ P
JMP JMP P
GOEND GOEND
IRET IRET
BREAK BREAK (d) P
RET RET
CHKST CHKST
CHK CHK
CHKCIR CHKCIR
CHKEND CHKEND
SFCP SFCP
SFCPEND SFCPEND
BLOCK BLOCK (s)
BEND BEND
*1
STEP? STEP? (s)
*2
TRAN? TRAN? (s)
TAND TAND (s)
TSET TSET (s)
SEND SEND
Function
Master control set
Master control reset
Main routine program end
Sequence program end
Conditional jump
*3
Delayed jump
Unconditional jump
Jump to END
Return from interrupt program
Repetitive forced end
Return from subroutine
CHK instruction start
Specific format error check
Check pattern change start
Check pattern change end
SFC program start
SFC program end
SFC block start
SFC block end
*1
SFC step start
*2
SFC transition start
SFC coupling check
SFC transition destination designation
SFC step end
4 SFC PROGRAM CONFIGURATION
*3
*3
*4
4.2 Steps
4
57