Audible User Feedback Tones; Group Call Tone/Individual Call Tone; Key Input Error Tone/Transpond Tone/Pre Alert Tone; Transmit Protection - Kenwood TK-7108 Service Manual

Hide thumbs Also See for TK-7108:
Table of Contents

Advertisement

TK-7108

7. Audible User Feedback Tones

The transceiver outputs various combinations of tones to
notify the user of the transceiver operating state.
Refer to the help file on the KPG-70D, regarding the func-
tions that are not listed below.
■ Stun on tone
When a stun code is received, transpond tone sounds.
■ Stun off tone
When a stun release code is received, transpond tone
sounds.
■ Group call tone
Sounds when a group call with the correct DTMF option
signalling is received, repeats 7 times. You can select yes or
no in the Alert tone level setting.
■ Individual call tone
Sounds when an individual call with the correct DTMF op-
tion signalling is received. You can select yes or no in the
Alert tone level setting.
■ Key input error tone
Sounds when a key is pressed but that key cannot be
used. You can select yes or no for the optional feature's
warning tone.
■ Transpond tone
Sounds when an individual call with the correct DTMF op-
tion signalling is received. For group calls, only the group
tone will sound, not the transpond tone.
■ Pre alert tone
Sounds prior to the TOT TX inhibit activation. If TOT pre
alert is set, the tone sounds at the amount of time pro-
grammed, before the TOT expires (TOT time – TOT pre alert
time = Pre alert tone sounding time). You can select yes or
no for the optional feature's warning tone.

■ Transmit protection

The power module is protected against heat while trans-
mitting by making the radio cuts down TX power when the
temperature of the power module becomes higher than ref-
erence. After that, if the temperature continue to rise, trans-
mission is stopped. The power module is also protected
against over voltage by having the radio to check that the volt-
age of power supply connected to the radio is not higher than
about 17V when the radio is turned on, otherwise it can not
transmit. In both cases when transmission is stopped, a
beep will continue to sound until the PTT key is released.
12
OPERATING FEATURES /
!
!"#$
TK=
!"#$%&'(%&)*
!" #$%&'( )*+hmdJTMa
!"#$%
!"#$%&'()*+,
!"#$%
!"#$%&'()*+,-.
!"#
!"#$%&aqjc
!"#$%&'()*+,-./
T
!"#
!"#$%&aqjc
!"#$%&'()*+,-.
!"#$%&'
!" #$%&'() #*+,-./0(123
!" #$ %&'()*+,-
!"#
!"#$%&aqjc
!" #$% &'(" )$%*+&'(,
!"#$%
! "#$%&'()*+,-qlq
qlq
!" #$%&'()*+,-=Eqlq
qlq
!"#$%&
'()*!"F
!"#$%&'()*+
!"
!"#$%&'()*+,-
! "#$%&'qu
!"#$%&'()*+,-."/+01234 567
!"#$%&'()*+,-./NT
!"#$%&'()*+,-./ 0%&123/ "45
!!"#$mqq
+,-./0
!"#$
!"#$%&'()*+ ,
!"#$%&'()*+
!"#$%&'()*+
!"
qlq
!"#$%&
!./0123
!"# $%&'()*+# ,-
! "#$%!
!"#$

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tk-8108

Table of Contents