Table of Contents
Advertisement
8. Rotate
and
BRIGHT
adjust the LCD's brightness and the DVD player's
volume.
9. To stop playing a disc, press
• When you stop playing a disc, the DVD player
remembers where you stopped.
• When you press
PLAY
again, the player picks up where you left off unless
you removed the disc or unplugged the DVD player.
10. To turn off the DVD player, press
player. The DVD player's POWER indicator turns off.
To turn off the display, slide
POWER indicator turns off.
16*'4"%100'%6+105
You can connect your DVD player to a TV, a TV and Audio/
Video receiver, a camcorder, a game system console, or a
digital camera.
%
"
100'%6+0)
61
Position Cables Properly to Avoid Audio
Interference.
• Insert each cable firmly into the
designated jack.
• If you place components above the
TV, route all cables down the side of
the back of the TV instead of straight
down the middle of the back of the TV.
• If your antenna uses 300-ohm twin
lead cables, do not coil the cables.
Also, keep the twin lead cables away
from audio/video cables.
1. Connect the supplied Audio/Video
cable's yellow plug to the
jack on the back of the DVD
OUTPUT
player and connect the yellow plug's
other end to the TV's Video Input jack.
2. Connect the supplied Audio/Video
cable's red plug to the
socket on the rear of the DVD
R
player. Connect the red plug's other
end to the TV's Audio Input Right jack.
, located below the LCD to
VOLUME
'.
STOP
J to start playing the disc
on the DVD
POWER
to
. The LCD's
OFF/ON
OFF
"
"68
#
VIDEO
AUDIO OUTPUT
11
Advertisement
Table of Contents
