GE GE314 Operating Manual page 65

Fingerprint access controller
Table of Contents

Advertisement

☞ "SCHEDULE ERROR" message shows when RFID card is read.
Cause
Error in RFID card registration, time schedule setting or the system itself.
Solution 1. If it was a properly operating unit before, there has been an electric shock that damaged the internal
memory and data. Please initialize the unit as instructed in the manual.
2. C
heck if ID information has been put in incorrectly during its registrat
* R
egister ID again checki
-In
order to restrict access of the ID user for specific time zone as instructed in the manual, register time
schedul
- In order to allow the user to access at all times, put in "00".
3. Use software for time schedule setting in case it is connected to PC as the software manual.
4. If the trouble remains after checking the above, contact a designated service center.
☞ "ACCESS DOOR ERR" message shows when the RF ID card is read.
Cause
Incorrect user setting or false of internal circuit.
Solution 1. If it was a properly operating unit before, there has been an electric shock that damaged the internal
memory and data. Please initialize the unit as instructed in the manual.
2. Check if ID information has been put in incorrectly
* Register ID again and check the following points:
- Since the c
(Reader1(Bilt-in reader) only: "1", Reader 2(Extra reader) o
- If RD is set as "1", only when the card is read at Reader 1, the door opens but not at Reader2. If it is
read at Reader 2, "ACCESS DOOR ERROR" message shows up.
- If RD is set as "2", only when the card is read at reader 2, the door opens but not a
at reader 1, "ACCESS DOOR ERRO
- If RD is set as "0 or 3", reader 1 & 2 both open each door.
3. If the trouble remains after checking the above, contact a designated service center.
ng the following points.
e in advance and appl
y the time schedule code(1~10) in the registration of the user ID.
ontroller has two reader ports, define "RD" – door for the user to be allowed to access
during its registration.
nly: "2", Reader 1 & 2 both: "0 or 3")
R" message shows up.
65
ion.
t reader1. If it is read

Advertisement

Table of Contents
loading

Table of Contents