Radio Shack XMODS 60-8512 Owner's Manual page 3

Screw
Location
Quantity
Upgrading the Front Section to Metal Bearings
1
Remove the four screws from the front upper deck to
detach it.
Long
3
Detach the knuckles and slide out the front axle shaft so
you can remove the two plastic bushings from each
knuckle and replace them with two metal ball bearings.
Standard Shaft
Bearings
Knuckle
www www www www www.xmodsRC.com .xmodsRC.com .xmodsRC.com .xmodsRC.com .xmodsRC.com
Screw Guide
Front and Rear Front Upper
Dampers Deck (long)
4 2
Short
All Wheel Drive Shaft
(Front of Car)
Front Upper Left and Right
Deck (short) Front Knuckles
2 4
2
Remove the top and bottom screws from the left and
right knuckles to detach the knuckles.
Knuckle
4
Remove the four screws to detach the front arm
base and the standard or all wheel drive assembly.
Front Arm
Base
4
Screws
All Wheel Drive Assembly
Standard
Assembly
3 3 3 3 3