Icom IC-RX7 Service Manual Addendum page 35

SECTION 3.
1. Removing the front panel
q Unscrew 4 screws from the rear panel.
4 screws
Rear panel
w Release the both sides of notches, and remove the front
panel.
DISASSEMBLY INSTRUCTION
3 - 1
2. Removing the LOGIC UNIT
q Unscrew total of 4 screws from the LOGIC UNIT.
w Unsolder 3 points at the rotary encoder (CONTROL
DIAL), then remove the LOGIC UNIT from the rear panel.
2 screws
LOGIC UNIT
Rear panel
3. Removing the MAIN UNIT
q Unscrew 5 screws from the MAIN UNIT
w Unsolder 1 point at the bottom of antenna conector, then
remove the MAIN UNIT from the rea panel.
Antenna connector
Unsolder
Unsolder
2 screws
Unscrew×5
MAIN UNIT