Flash-To-Pass; Daytime Running; Lamps (Drl); Automatic Headlamp - Chevrolet TRAX 2018 Owner's Manual

136

Lighting

This indicator light turns on in the
instrument cluster when the
high-beam headlamps are on.

Flash-to-Pass

To flash the high beams, pull the
turn signal lever all the way toward
you. Then release it.

Daytime Running

Lamps (DRL)

Daytime Running Lamps can make
it easier for others to see the front of
your vehicle during the day. Fully
functional DRL are required on all
vehicles first sold in Canada.
A light sensor on top of the
instrument panel makes the DRL
work, so be sure it is not covered.
The DRL system makes the
low-beam headlamps come on at a
reduced brightness when the
following conditions are met:
The ignition is on.
The exterior lamp control is
in AUTO.
The engine is running.
When the DRL are on, only the
low-beam headlamps, at a reduced
level of brightness, will be on. The
taillamps, sidemarker, instrument
panel, and other lamps will not
be on.
The headlamps automatically
change from DRL to the regular
headlamps depending on the
darkness of the surroundings. The
other lamps that come on with the
headlamps will also come on.
When it is bright enough outside,
the headlamps go off and the DRL
come on.
To turn the DRL off or on again, turn
the exterior lamp control to the off
position and then release. For
vehicles first sold in Canada, the
DRL can only be turned off when
the vehicle is parked.

Automatic Headlamp

System

If equipped, the headlamps come on
automatically when it is dark enough
outside and the exterior lamp
control is in the automatic position.
See Exterior Lamp Controls 0 135.
The vehicle has a light sensor on
top of the instrument panel. Make
sure it is not covered, or the
headlamps will be on when they are
not needed.