Listening Through Another Audio Component; Troubleshooting - Radio Shack Hi-Power CD+G Karaoke System Owner's Manual

LISTENING THROUGH
ANOTHER AUDIO
COMPONENT
If you connected an audio component (such
as a PA system) to your karaoke system, fol-
low these steps to listen to the karaoke sys-
tem's sound through that component.
1. Press to turn on the system.
STANDBY
STANDBY turns off.
2. Set
FUNCTION SELECTOR
lights.
ˆ

Troubleshooting

If you have problems operating your Hi-Power CD+G Karaoke System, use this chart to deter-
mine the problem and possible solutions. If you still have problems, contact your local
RadioShack store for assistance.
Problem
The karaoke system does not
work.
A CD/CD+G is loaded, but the
CD/CD+G player does not
start.
16
3. Turn on the audio component.
4. Play a cassette, CD, or CD+G in the
karaoke system.
5. Use the controls to adjust the sound. To
sing along with a CD or CD+G, see
"Singing with a CD/CD+G or Cassette
Tape" on Page 8.
6. To turn off the system, press
STANDBY lights and AUX turns off.
Then turn off the audio component.
to . AUX
AUX
Possible Cause
No power.
Power is on standby.
The CD/CD+G is loaded
upside down.
The CD/CD+G is dirty or
defective.
Moisture has condensed
on the pickup lens.
Troubleshooting
STANDBY
Solution
Make sure the power cord is
properly plugged into an AC
outlet.
Make sure STANDBY is off.
Reload the CD/CD+G, label
side up.
Clean the CD/CD+G and
reload it, or try a different
CD/CD+G.
Unplug the system and wait
1 hour for the moisture to
evaporate.
.