Parts And Their Functions; Top Panel - Korg KR-55 PRO Owner's Manual

Hide thumbs Also See for KR-55 PRO:
Table of Contents

Advertisement

Parts and their functions

Top panel

1. Mixer section
2. Select section
3. Control section
1. Mixer section
MIC IN jack (XLR jack)
Connect a dynamic mic here.
Condenser mics are incompatible with the KR-55 Pro.
INPUT 1 jack, INPUT 2 jack
Connect a guitar, bass, or other instrument to these jacks.
TUNER button
Turns the tuner function on.
ACOUSTAGE button
Switches the Acoustage (wide) function on/off.
The Acoustage function cannot be used while recording.
Turn the Acoustage (wide) function off when using
headphones. The Acoustage function is optimal when
connecting stereo speakers to the OUTPUT L/MONO and
R jacks.
Power button
Turns the power on.
See page 8 "Turning the power on/off"
3-b: Function buttons
3-a: Mode buttons
1: GND
3: COLD
2: HOT
Parts and their functions
3-c: Control buttons, VALUE dial,
Display
Note: The power button blinks rapidly if the batteries become
low while the KR-55 Pro is running on batteries.
The KR-55 Pro has an auto power-off function. The auto
power-off function automatically turns off the power when
there has been no user input for a certain length of time (which
you can specify). If the auto power-off function has turned the
power off, simply turn it back on again.
Tip: You can specify the time after which the auto power-off
turns the power off (see page 23 "[M3] Auto power-off
function "APOF"").
MIC knob, peak LED
This knob adjusts the input level from the mic that's connected
to the MIC IN jack. To avoid signal clipping (signal that's
too loud) this knob should be adjusted so that the peak LED
doesn't light up when signal is being input at a high volume
level.
(INPUT) 1 knob, (INPUT) 2 knob, peak
LED
These knobs adjust the input level from the instruments that
are connected to INPUTS 1&2. To avoid signal clipping (signal
that's too loud) each knob should be adjusted so that the peak
LED doesn't light up when signal is being loudly input.
The peak LED is shared by INPUT 1 and INPUT 2. If you're
using both input jacks, adjust the knobs for both INPUT 1 &
INPUT 2.
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rhythm kr-55 proKr-55 pro

Table of Contents