Preparation; Connecting To An Audio Source; Using Ac Power - Radio Shack 33-1185 Owner's Manual

33-1185.fm Page 4 Wednesday, November 10, 1999 10:29 AM

PREPARATION

CONNECTING TO AN
AUDIO SOURCE
Caution: Do not connect the transmitter
to the audio source's speaker output.
Doing so could damage the transmitter
and audio source.
Connect the transmitter to your audio
source's stereo headphone jack or to
separate left and right audio output jacks
(if available). If you connect the transmit-
ter to audio output jacks, you can use
the headphones' volume control to ad-
just the volume without turning up the
volume on your audio source.
To connect the transmitter to your audio
source's stereo headphone jack, plug
the single ( 1 / -inch) end of the supplied Y
8
adapter cable into the headphone jack
and connect the other ends into the sup-
plied stereo audio cable (red plug to red
jack and white plug to white jack). Then
connect the red plug to transmitter's
jack and connect the white
AUDIO IN
plug to the
L/AUDIO IN
4
Note: To connect a Y-adapter to a
inch headphone jack, slip the supplied
1
plug and complete the connections.
To connect the transmitter to your audio
source's audio output jacks, connect
one end of the supplied stereo audio ca-
ble to the transmitter's
R/AUDIO IN
IN
plug the other ends into the audio
source's audio output jacks (red plug to
the right channel and white plug to the
left channel).
R/
jack.

USING AC POWER

Use the supplied 12-volt, 100-mA AC
adapter to connect the transmitter to AC
power.
/ -inch adapter plug over the
4
jacks (red plug to
and white plug to
L/AUDIO IN
1 / -
4
/ -inch
1
8
and
R/AUDIO IN
R/AUDIO
). Then