Table of Contents
Advertisement
1-2. TEMPORARILY
SEITING
UP AND CONNECTING
CP-1 PWB ASSEMBLY
The following is an example of how to place and connect the main board without a jig, when repairing the CP-I PWB assembly.
1.
Place the mechanism unit and main board up side down as
2.
Operete the unit using the buttons on TM-1 PWB or the
a whole on a flat surface with foil side of the main board
remote control.
facing up.
M-PF2HNiTA-4
CP-1
PWB Assembly
(Foil side)
\
\
TM-2
PWB
Fig. 1-1-4
1-3. INSTALLATION
OF THE FRONT PANEL
When installing the front panel to the chassis after repaires and adjustments.
1.
Pressing
down
the door
opener
lever
of the mechanism
Note: Opened cassette door position does not install the front
main unit.
panel to the chassis.
2.
Set the cassette door to half-opened state as shown in Fig.
1-1-5, and install the front panel to the chassis.
M-PF2HN~A-5
Jutted Dart of
Front
(Position
B)
Fig. 1-1-5
–7-
Advertisement
Table of Contents
