Table of Contents
Advertisement
Installation and Operation
Mount Using EX Mounting Bracket
Install the Mounting Bracket
To mount the endpoints using the optional EX Mounting Bracket Accessory (PN 790080)::
1.
Use the included template to mark the correct drilling locations on the mounting surface.
2. Attach the mounting bracket to the surface using the screws included in the EX Mounting Bracket
Accessory kit.
3. Remove the wing brackets attached to the endpoint by removing the two (2) screws that attach
each wing brackets to the endpoint.
4. Place the endpoint against the installed mounting bracket. The endpoint adheres to the mounting
bracket magnetically.
Install the L-Shaped Retention Brackets
Use the optional L-shaped mechanical retention brackets with the EX Mounting Bracket Accessory to
provide additional connection points between the endpoint and the mounting bracket.
To mount the endpoint using the L-shaped retention brackets:
1.
Attach the L-shaped retention brackets to the endpoint, using the enclosed screws. Attach one
bracket to each side of the endpoint (front and rear), in opposite corners.
2. Position the endpoint on the installed mounting bracket.
3. Attach the L-shaped retention brackets to the mounting bracket, using the screws included in the EX
Mounting Bracket Accessory kit.
10 - Installation Guide
pro.Bose.com
Advertisement
Table of Contents
