Table of Contents
Advertisement
1
"
"9
"
"9
0
#
#..
14
To mount the base directly on the wall, you need two screws
(not supplied) with heads that fit into the keyhole slots on
the bottom of the bracket. Drill two holes 3
Then thread a screw into each hole, letting the heads
5
extend about
/
inch from the wall.
32
1. Insert the two tabs
at the top of the
narrow end of the
supplied bracket
into the base's
upper tab slots,
then press down
on the bracket's
latches and insert
them into the clip
slots.
2. To connect the phone to a two-line phone jack , plug
one end of the supplied long modular cord into the
jack on the back of the phone.±
TEL LINE 1/2
To connect the phone to two one-line phone jacks , plug
one end of the supplied short two-line modular cord into
and plug another cord (not supplied) into
TEL LINE 1/2
the
jack.
TEL LINE 2
To connect the phone to a single one-line phone jack ,
plug one end of the supplied long modular cord into the
or
TEL LINE 1/2
TEL LINE 2
3. Insert the supplied AC adapter's barrel plug into the
jack on the back of the base.
DC IN 9V
4. Route the adapter's
cord through the
narrow groove on the
bracket. If you are
using two phone cords,
route the second cord
through one of the
wide grooves on the
bracket.
"2
#..
.#6'
15
/
inches apart.
16
jack.
±
±
"016'"
"
If you connect the phone to a two-
line phone jack with a two-line
cord, do not connect a cord to the
TEL LINE 2 jack or the phone will
not operate properly.
7
Advertisement
Table of Contents
