Remote Operation - Radio Shack 43-3880 Owner's Manual

Ô
NOTES
• Time stamp will not be
heard until you have set
the time. See "Setting
the Time" on page 54.
• The system will only
playback messages for
four minutes and then it
returns to the command
waiting mode. To
continue playing your
messages, press 0 then
2 again within 15
seconds.
• If you enter an incorrect
PIN code three times,
you will hear a beep and
the system will return to
standby.
• During the remote
operation,
"Line Remote"
appears on the handset.
• If the answering system
is recording an incoming
message, the recording
operation is canceled
when you start remote
operation.
64
3. To stop recording, press the
key and
select
the
confirmation tone.
From the base
1. During a conversation using the base
speaker phone, press and hold
MEMO/REC
confirmation tone. The unit begins
recording and "- -" flashes on the display.
Ô
A confirmation tone, that can be heard by
both parties, sounds during recording.
2. To stop recording, press
or
tone.
R
EMOTE
You can check, play, or delete messages,
even record a new greeting message from a
remote location (when you are away from
home, or from another room using a
handset). Additionally, you can turn On or
Off your answering system remotely. Ô
Remote access away from home
You can operate your answering system
from a remote location using any
touch-tone telephone.
1. Call your telephone number and wait
for the system to answer. If the
answering system is off, it will answer
after about ten rings and sounds a
series of beeps.
2. During the greeting message (or a
series of beeps when the answering
system is off), press 0 and enter your
PIN code within two seconds (see
"Setting a PIN Code" on page 21 or 55).
VOL/RING/
Call Record
soft key. You will hear a
OK
on the base until you hear a
. You hear a confirmation
MEMO/REC
O
PERATION
soft
MENU
or to
VOL/RING/
, and then press
PLAY/ STOP