(2) Removing tapes and spacers
Remove the tapes and spacers as follows before machine installation.
1. Remove the tape securing the hook.
2. Remove two tapes and then remove the
sheet.
3. Remove two tapes securing the signal cable
and base retainer.
4. Remove two tapes and then remove the air
padded bag.
5. Remove two tapes securing the upper and
right covers.
Y110900-9
Sheet
Tape
Signal cable
Tapes
Upper cover
Tape
Service Manual
Hook
Tapes
Base retainer
Figure 1-2-2
Right cover
Figure 1-2-3
3MV
Tape
Tape
Tape
1-2-3