Yamaha RX-V100D Service Manual page 29

19. SOFT SW
Note) Changing the function setting may hinder the proper operation.
This menu is used to switch the function settings on P.C.B. through the software so as to activate the product.
The protection function follows the P.C.B. settings. When connected to AC or in the maker preset state, the unit is initialized
to the P.C. B. setting. Display of each function after initialization varies depending on settings on P.C.B. The operation mode
can be changed by selecting the sub-menu and then using the STRAIGHT key.
SW MODE: PCB, MODEL or FNC can be selected.
MODEL SETTING: V100D, V757, V657, H5860, V557, V457, H5850 or V357 can be selected.
(SW MODE: Selectable when MODEL has been selected.)
DESTINATION: J, U, C, R, T, K, A, B, G (E) or L can be selected.
(SW MODE: Selectable when MODEL has been selected.)
TUNER DESTINATION: J, UC, R, ABG or RL can be selected.
(SW MODE: Selectable when FNC has been selected.)
TUNER TYPE: NRM, DAB+RDS ,DAB, RDS or XM can be selected.
(SW MODE: Selectable when FNC has been selected.)
VIDEO FORMAT: NTSC or PAL can be selected.
(SW MODE: Selectable when FNC has been selected.)
ZONE2: NOT or EXIST can be selected.
(SW MODE: Selectable when FNC has been selected.)
AAC: NOT or EXIST can be selected.
(SW MODE: Selectable when FNC has been selected.)
TUNER: NOT or EXIST can be selected.
(SW MODE: Selectable when FNC has been selected.)
ZONE2 AMP: NOT or EXIST can be selected.
(SW MODE: Selectable when FNC has been selected.)
OSD: NOT or EXIST can be selected.
(SW MODE: Selectable when FNC has been selected.)
YPAO: NOT or EXIST can be selected.
(SW MODE: Selectable when FNC has been selected.)
RX-V100D
29