Table of Contents
Advertisement
1.3 Fastening the Radiator to
the Radiator Bracket
For your reference, scanner installation ma-
terials list appears in the packing lists at the
back of this manual.
1. Remove the radiator cap from the radia-
tor bracket.
2. Coat contacting surface between scan-
ner radiator and radiator bracket with an-
ticorrosive sealant as shown in Figure 1-2.
Coat hatched area with
anticorrosive sealant.
Figure 1-2 Coating the bottom of
scanner radiator for XN10A with
anticorrosive sealant
3. Coat threaded holes on the scanner ra-
diator with anticorrosive sealant.
4. Grease the O-ring and set it to the radia-
tor bracket.
5. Lay the scanner radiator on the radiator
bracket.
6. Coat the radiator fixing bolts (4 pcs.) with
anticorrosive sealant. Fasten the scanner
radiator to the radiator bracket with the
radiator fixing bolts, flat washers and
spring washers.
1-2
Radiator bracket
Groove
Figure 1-3 Fastening the radiator bracket to
Radiator
1.4 Mounting the Scanner Unit
The scanner unit can be mounted using the
fixing holes on the outside (200 x 200 mm)
or inside (140 x 150 mm) the scanner unit.
Outside fixing holes
Use the hex head bolt ( supplied ) to mount
the scanner unit as below.
1. Lay the corrosion-proof rubber mat (sup-
Bow mark
Scanner
radiator
O-ring
Flat washer
Spring washer
Hex head bolt
(M8 x 30)
the scanner unit chassis
plied) on the mounting platform.
Figure 1-4 Location of rubber mat
Coat threaded
holes with anti-
corrosive
sealant.
Coat bolts with
anticorrosive
sealant.
Ground
terminal
Rubber
mat
Advertisement
Table of Contents
