Table of Contents
Advertisement
Mounting
The display unit is mounted in a hanger. The
mount itself can be installed either overhead,
on a bulkhead, or on a tabletop. The drawing
below gives the recommended clearances
and mounting dimensions for this unit. You
can use the mount itself as a template for
locating the mounting screw holes. Although
the unit is lightweight (4.8 kilograms), rein-
force the mounting place, if necessary.
1. Mark the screw locations by using the
hanger as a template.
2. Drill five pilot holes for the hanger.
3. Install the hanger using the screws sup-
plied as the installation materials.
4. Fit the knob bolts and washers to the dis-
play unit.
5. Install the display unit in the hanger.
Tighten the knob bolts securely.
300 mm
(11.79'')
223 mm
(8.78'')
5-7.5
MOUNTING HOLES
80 mm
(3.15'')
232 mm
(9.13'')
70 mm
(2.76'')
160 mm
(6.30'')
Figure 1-9 Display unit, outline drawing
276 mm
(10.87'')
196 mm
(7.72'')
224 mm
(8.82'')
80 mm
80 mm
(3.15'')
(3.15'')
WASHER
KNOB
BOLT
1-5
Advertisement
Table of Contents
