Honeywell STT850 Quick Start Manual page 21

Sensor n ID
(HART/FF)
(FF read only)
Database
updates take 30
seconds to
complete. Do not
interrupt power.
Sensor n Wire
Type (HART/FF)
(FF read only)
Sensor n Lead
(HART/FF)
(FF read only)
Sensor n Bias
(HART/FF)
(FF read only)
Sensor n Cal Lo
Pt (HART/FF)
(FF read only)
Sensor n Cal Hi
Pt (HART/FF)
(FF read only)
Do Sensor n Cal
Lo (HART/DE)
Do Sensor n Cal
Hi (HART/DE)
Sensor n LRV
(FF only)
Sensor n URV
(FF only)
Reset Sensor n
Cal (HART/DE)
September 2017
Select Sensor ID for Input n for
Sensor
selected Sensor Type. (Input 1
Identifier
selection or dual input model).
2-Wire,
Select the number of lead wires
3-Wire,
for RTD and Ohm sensors.
4-Wire
Sensor lead wire resistance
####.## value. (only if RTD type is 2
wire)
####.## Bias on the measured value
####.## Calibration low point for Sensor n
####.## Calibration high point for Sensor n
Executing this selection corrects
Confirm the Cal Low Point based on the
input measurement
Executing this selection corrects
Confirm the Cal High Point based on the
input measurement
Lower Range Value
####.##
representing 0% output
Upper Range Value
####.##
representing 100% output
Executing this selection Resets
Confirm the LRV, and URV Corrects
back to Factory values
Quick Start Installation Guide
SmartLine Temperature Transmitter
Press ↵ to
enter
menu
selection
↑ and ↓ to
select
entry.
↵ to enter
Read Only
Parameter
Read Only
Parameter
Press ↵ to
enter
menu
selection
↑ and ↓ to
select
entry.
↵ to enter
21