Wiring Variations
The above procedures are used to connect power to a Transmitter. For loop wiring
and external wiring, detailed drawings are provided for Transmitter installation in
non-intrinsically safe areas and for intrinsically safe loops in hazardous area locations.
This procedure shows the steps for connecting power to the transmitter.
Wiring must comply with local codes, regulations and ordinances. Grounding
may be required to meet various approval body certification, for example CE
conformity. Refer to the SmartLine Transmitter User's Manual 34-TT-25-03
(STT850) or 34-TT-25-06 (STT850) for details.
Input Sensor Wiring
Connect the input sensors as shown in Figures below:
Figure
9:
DE Single Input Wiring Diagram.
RTD Thermocouple, mV and Ohm Connections
10
Figure 9: DE Single Input Wiring Diagram
Quick Start Installation Guide
SmartLine Temperature Transmitter
September 2017