Radio Shack 43-324 User Manual page 35

Caller ID entries do not match the numbers I need to dial.
• Although the call log entries you receive have 10 digits, (the area code
plus the seven-digit number,) in some areas, you may need to dial only
seven digits, or a 1 plus the seven digits, or a 1 plus the area code plus
the seven digits. You can change the number of digits that you dial or
store from the call log.
• While reviewing the call log, press # repeatedly to display these dialing
options for local and long distance numbers before dialing or saving the
telephone number.
My cordless handset beeps and is not performing normally.
• Make sure the power cord is securely plugged into the telephone base.
Plug the unit into a different working electrical outlet not controlled by a
wall switch.
• Move the handset closer to the telephone base. It may be out of range.
• Reset the telephone base by unplugging the unit's electrical power. Wait
for 15 seconds and plug it back in again. Allow up to one minute for the
handset and the telephone base to synchronize.
• Other electronic products can cause interference to your cordless
telephone. Try installing your telephone as far away from these
electronic devices as possible: wireless routers, radios, radio towers,
pager towers, cellular telephones, intercoms, room monitors, televisions,
personal computers, kitchen appliances and other cordless telephones.
Common cure for electronic equipment
If the unit is not responding normally, try putting the handset in the
telephone base. If it does not respond, try the following (in the order listed):
• Disconnect the power to the telephone base.
• Disconnect the battery on the handset.
• Wait a few minutes before connecting the power to the telephone base.
• Re-install the battery and place the handset in the telephone base.
• Wait for the handset to synchronize with the telephone base. Allow up
to one minute for this to take place.
35