Downstream From Step Controller; Local Operation; General Information On Operation - ABB EBN853 Operating Instructions Manual

Local operation

5.3.2

Downstream from step controller

Fig. 17: Potential wiring for "Downstream from step controller" operation
Positions for the potential switch
(See page 25 Fig. 18: pos. 8)
Name:
Position A:
Position B:
Important
In this operating mode, the switch for the reference potential must be in position
Pos: 13 /======= Seitenumbruch ======== @ 0\mod_1126532365768_3101.doc @ 3830
Pos: 14.1 /Überschriften/1/J - L/Lokale Bedienung @ 1\mod_1144311291828_3101.doc @ 5751
6 Local operation
Pos: 14.2 /Überschriften/1.1/1-spaltig/A - C/Allgemeine Informationen zur Bedienung @ 7\mod_1167724521984_3101.doc @ 53616
6.1

General information on operation

Pos: 14.3 /Konfiguration, Parametrierung/Aktorik/Antriebe/Contrac/Lokale Bedienung/Allgemeine Informationen zur Bedienung @ 7\mod_1166523369281_3101.doc @ 53108
The basic settings "Define end positions" and "Initial diagnosis" can be configured via the
commissioning and service field (ISF). It can be used to adjust the actuator to the working area
and set the direction without using a PC. The actuator can be further parametrized using a
graphic user interface.
Important
The commissioning and service field is located on the electronic unit.
Pos: 14.4 /Konfiguration, Parametrierung/Aktorik/Antriebe/Leistungselektroniken/EBN853, EBN861/Hinweis ECOM688 @ 17\mod_1199701769718_3101.doc @ 149843
Important
Observe the information about using the engineering software Save & Restore or ECOM688 in
chapter 2.2.
Pos: 14.5 /======= Seitenumbruch ======== @ 0\mod_1126532365768_3101.doc @ 3830
24
INT
SYS
EBN853, EBN861 (Contrac)
.
42/68-830-EN