Radio Shack 63-1037 Owner's Manual

™
www.radioshack.com
OWNER'S MANUAL —
Please read before using this equipment.
Wall Mount Holder — Use to mount
the thermometer on a wall.
Removeable Stand — Use to set
thermometer on a table or other flat surface.
Channel 1/2/3 — Slide to Channel 1, 2, or 3. Set
to a different channel than the other remote
sensors you are using.
y y y y
— Appears if the batteries are weak.
± ±
"016'" "
Operation
• Do not set two or more thermometers to the
same channel when using them with one
main unit. Otherwise you will unable to judge
which thermometer the digits represent.
• Your thermometer comes with a protective
film covering the display which should be
removed before use.
Selecting a Location
The construction of your home or office might
affect the transmission range between the
main unit and the thermometer. If you have a
choice of several locations, try each to see
which provides the best performance.
R R
"9#40+0)"
Dispose of old batteries promptly and properly.
Do not burn or bury them.
. .
"%#76+10"
• Use only fresh batteries of the required size
and recommended type.
• Do not mix old and new batteries, different
types of batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of
different capacities.
• If you do not plan to use the thermometer for
a month or more, remove the batteries.
Batteries can leak chemicals that can
destroy electronic parts.
If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon
for pertinent information.
R R R R ý
#
— Warning — Important
Thank you for purchasing the RadioShack
Wireless Pool/Spa Thermometer. Your
thermometer measures water temperature,
and is useful in swimming pools, hot tubs,
and freezers. It is for use with an in/out
thermometer (not supplied, available at your
local RadioShack store or online at
www.radioshack.com). The supplied wall
mount holder and stand let you mount it
wherever you like.
+056#..+0)"
$#66'4+'5
Your thermometer requires two AA batteries
(not supplied) for power. For the best
performance and longest life, we
recommend RadioShack alkaline
R R R R ý
. . . .
batteries.
1. Remove the wall-mount holder from the
back of the thermometer.
2. Use a Phillips screwdriver to loosen the
screws on the battery compartment
cover and remove the cover.
C/ F
CHANNEL 1/2/3
Battery
Compartment
Cover
# #
"+/2146#06"
. . . .
± ± ± ±
— Note — Caution
9KTGNGUU"2QQN15RC"6JGTOQOGVGT
Liquid Crystal Display — The
current temperature and selected
channel appear.
Temperature Sensor Probe — Place it in
water to test the temperature.
°C / °F — Select Centigrade (°C) or
Fahrenheit (°F) for your desired degree
format.
3. Slide
setting, then press
channel appears on the display.
4. Slide
5. Place two batteries in the compartment
as indicated by the polarity symbols
(+ and –) marked inside.
6. Replace the cover and secure it with the
screws.
12'4#6+10
Place the temperature sensor probe where
you want to test. The current temperature
and selected channel appear. Signals
transmit to the main unit about every 30
seconds. ±
4
'5'66+0)
If your thermometer stops working properly,
use a pointed object to press
resets the temperature and reinitializes the
sensor transmitter.
RESET
/1706+0)
Place your thermometer on a flat surface
using the supplied stand, or mount it on the
wall using screws (not supplied) and the
supplied holder.
5
'.'%6+0)
Choose an indoor or outdoor location for
your thermometer that is within 60 – 90 feet
(20 – 30 meters) of the main unit. ±
RadioShack and RadioShack.com are trademarks used by
° ° ° °
— Hint
63-1037
to the desired
CHANNEL 1/2/3
. The selected
RESET
to the desired setting.
C/ F
R R R R ý
± ± ±
" "5
6*' ;56'/
. This
RESET
" ".
# 1%#6+10
± ± ±
©
2002 RadioShack Corporation.
All Rights Reserved.
RadioShack Corporation.