Drivers And Software; Driver Installation For Windows Embedded Standard 7 And 2009; Installing Drivers And Software - Siemens SIMATIC IPC277D Operating Instructions Manual

8.4.3

Drivers and software

8.4.3.1

Driver installation for Windows Embedded Standard 7 and 2009

The drivers for Windows Embedded Standard are installed as in Windows XP Professional.
Pay attention to the installation instructions of the driver manufacturer.
Procedure
If the message "Windows XP installation CD required" appears when you install drivers,
proceed as follows:
1. If your device has no CD/DVD drive, connect an external USB CD/DVD drive to a USB
port.
2. Insert the recovery CD/DVD.
3. The necessary ".cab" files can be found in the "\Drivers_WES" folder. Unpack the ".cab"
files to a folder on the local hard disk.
4. Disable the Enhanced Write Filter before installing drivers and enable it again when you
are finished.
8.4.3.2

Installing drivers and software

Introduction
Note
In the case of multilingual operating systems (MUI versions), you have to set the regional
settings for menus and dialogs and the default language to English (US) before you install
new drivers or operating system updates.
Procedure
1. If your device has no CD/DVD drive, connect an external USB CD/DVD drive to a USB
port.
2. Insert the "Documentation and Drivers" CD/DVD provided.
3. Start the "START" program.
4. Select "Drivers" from the index.
5. Select the device and operating system.
6. Select the desired driver
SIMATIC IPC277D
Operating Instructions, 12/2016, A5E03409486-AE
Device maintenance and repairs
8.4 Installing the software
105