Trouble Shooting - Pyle PLCDCS 200 Owner's Manual

Mobile audio system
Table of Contents

Advertisement

TROUBLE SHOOTING

Before going through the check list, check wiring connection. If any of the problems
persist after check list has been made, consult your nearest service dealer.
Symptom
No power.
Disc cannot
be loaded or
ejected.
Cassette tape
cannot be
loaded or
ejected.
No sound.
Sound skips
or sound
quality is poor.
The operation
keys do not
work.
The radio does The antenna cable is not
not work. The
radio station
automatic
selection does
not work.
Cause
The car ignition switch is
not on.
The fuse is blown.
Presence of CD disc inside Remove the disc in the player, then
the player.
Inserting the disc in
reverse direction.
Compact disc is extremely Clean the disc or try to play a new
dirty or defective disc.
Temperature inside the car
is too high.
Condensation.
Presence of a cassette
tape in the player.
The temperature in the car
is too high.
Condensation.
Volume is in minimum.
Wiring is not properly connected.
The installation angle is
more than 30 degrees.
The disc is extremely dirty
or defective disc.
The cassette is defective.
The built-in microcomputer Press the RESET button.
is not operating properly
due to noise.
connected.
The signals are too weak.
If the power supply is properly
connected to the car accessory
circuits, but the engine is not moving,
switch the ignition key to "ACC".
Replace the fuse.
put a new one.
Insert the compact disc with the
label facing upward.
one.
Cool off or until the ambient
temperature return to normal.
Leave the player off for an hour or
so, then try again.
Remove the cassette tape in the
player, then put in the new one.
Cool off the inside of the car, then try
again.
Leave the cassette player off for an
hour or so, then try again.
Adjust volume to a desired level.
Check wiring connection.
Adjust the installation angle to less
than 30 degrees.
Clean the compact disc, then try to
play a new one.
Try another cassette.
Front panel is not properly fixed into
its place.
Insert the antenna cable firmly.
Select a station manually.
10
Solution

Advertisement

Table of Contents
loading

Table of Contents